AirScooter G70 UAV with Internal Combustion Engine
(click on image for larger view)


Main Rotor Diameter:

Rotor Hub Type:


Main Rotor Blade Type:


Main Rotor Max. Speed:

Rotor Clutch:

Main Rotor Control Type:


Pitch and Roll Control:

Yaw Control:

Altitude Control:

RPM Control:

Transmission:


Transmission Ratio:

Engine Type:


Engine Mount:

Engine Size:

Engine Power:


Engine Clutch:


Fuel:

Fuel Capacity:

Height:

Weight (empty):

Duration (hover):

Payload:

Total Thrust:

Max Speed @ 1000 RPM:

Noise Level:

2 Bladed dual (coax) 69.60 in. (1768mm)

Both spring loaded teetering (semi-rigid)
Both rotors friction damped

Composite blade, non-twisted semi-symmetrical
high-lift airfoil

1100 rpm

Sprag type clutch installed on 2-Stage

'Beller', cyclic and collective (mast mounted) upper
rotor, collective-only lower rotor

±10° Cyclic on upper rotor

±2° Differential collective

±5° Collective (both rotors)

Throttle governor

2 Stage, spur gears, steel pinions - nylon bulls,
all ball bearing

8.533:1

2 Cycle, 2 cylinder opposed, gas with air-cooling
and electric start

Isolated, four point (not dyne-focal)

86 cc

6.5 Shaft horsepower @ 9000 rpm after
muffling and cooling

Centrifical, isolated from engine by using
constant velocity Thomas type couplings

Gas and oil mix

64 Fluid ounces

44.92 in. (915mm)

32 lbs.

3/4 Hour, 2-hour battery for controls

10+ lbs.

70 lbs. at sea level (70° Day)

50 mph

Approximately 100 db at 10 feet (equivalent to
standard weed eater).

 



AirScooter E70 UAV with Electric Motor
 (click on image for larger view)

Main Rotor Diameter:

Rotor Hub Types:


Main Rotor Blade Type:


Main Rotor Max. Speed:

Rotor Clutch:

Main Rotor Control Type:


Pitch and Roll Control:

Yaw Control:

Altitude Control:

RPM Control:

Transmission:


Motor Type:

Motor Power:

ESC (Electronic Speed Control):

Cells:

Height:

Weight (with batteries):

 Duration:

Payload:

Max Forward Speed:

2 Bladed dual (coax) 69.60 in. (1768mm)

Both spring loaded teetering (semi-rigid)
Both rotors friction damped

Composite blade, non-twisted semi-symmetrical
high-lift airfoil

1100 rpm

1-way needle bearing installed on 2 Stage

'Beller', cyclic and collective (mast mounted) upper rotor,
collective-only lower rotor

±10° Cyclic on upper rotor

±2° Differential collective

±5° Collective (both rotors)

Throttle governor

2 Stage, spur gears, steel pinions - nylon bulls,
all ball bearing

Brushless

3000 watts continuous

125 amps continuous

10S4P 15 Amp Lithium Poly

39.12 in. (915mm)

32 lbs.

About 12 minutes

1 - 4 lbs.

About 40 mph